Construct 3 remote preview issue

Construct 3 remote preview fails for me if i try to open a link in few minutes after creating, gives an error join-failed, before it was working.

Is it for everybody or just for me?

just for you.

Make sure you have the construct.net site listed as a site that can use data and cookies ect in your browser. Also make sure you didn't accidentally block the site with windows firewall or are running an a windows protection or anti-virus that you have to enable things to use networking on a webpage. Only other thing I can think is make sure you have open access to the port being used in your router.

I have used construct preview with many different computers and internet connections and have never had a problem before otherwise I might have a better suggestion of what the issue might be.

Here is an error i'm getting

I assume it's not a matter of firewall/antiwirus/routing as far no configuration changes were done to above. I have tried another browser to remove the factor of cache and cookies. Still the same, and does that with any project, including the examples.

Around 4 minutes after preview first launched, opening a link in new window gives an error.

You have probably understood the point wrong, remote preview does work.

First you launch it, and it works. Few minutes after - i refresh window with f5 or by opening a new window and entering the link, and all what i can see is this:

I am having the same issue with the remote preview. I pasted the link into the development tablet and it's the same thing. It's been like that for two days.

i having the same issue with the remote preview

I am having issues with remote preview for last few days as well. It disconnects within a minute every time. So frustrating to deal with.