Bullet Behaviour Stops

Hello everybody,

I'm new here and I'm still getting used to Construct 2. I'm trying to simulate an object falling down when there's any other object touching it. To do that, I'm using the bullet behaviour and I've set it's angle to 90 degrees.

It happens that when the bullet behaviour is enabled, it just runs for a little moment and then stops. I think I've made some dumb mistake (I hope so) but I simply can't see where. Could you help me?

Here it goes the link of the .capx file:

dropbox.com/s/qxtgamkbxtbjo18/Bullet-is-stopping.capx

Thanks!

Hey mate,

The problem is in the 'stones overlapping' group. While the stone is overlapping the those border objects it disables the bullet. So if you just toggle 'set bullet disabled' off you will see the stone continues to drop. Hope that helps!

I can't believe it was just that simple!! Thank you a lot!