How do I make a ball stop?

Hi friends,

I have a ball that doesn't want to stop. It's like the friction is not enough and only 0 to 1 values are available, so I don't know what to do.

I made a code to slow it down but it's so cheap and not always effective. Am I missing something?

I'm trying to change the density and raising the world gravity, but it still goes on and on.

Thanks!

angular damping

Angular damping

The rate the object slows down over time while spinning, from 0 (no slowdown at all) to 1 (maximum slowdown).

The above answers were right. I was searching for this exactly today. I missed to check this below manual. You should check this too.

https://www.scirra.com/manual/98/physics

Okay. I have a problem here.

Both the angular and Linear Damping were 1. But the ball still not settling here. Is this because of the bullet behavior's gravity. why?

Somebody help????

hi Harishankar

i dnt know which point you want ball to stop

but here is capx

it just an idea but not good solution

Thanks — but this is not what i want. I want it to settle quickly.

The damping should happens bit more quickly. Can anybody help with my file.

—

You can't mix Physics with Bullet or Solid. Get rid of all solid, bullet behaviours and set everything to physics. Initiate your movement with Apply impulse.

—

You can't mix Physics with Bullet or Solid. Get rid of all solid, bullet behaviours and set everything to physics. Initiate your movement with Apply impulse.

blackhornet could you plz show me how with that file?

.

blackhornet Thanks mate. I see what you have done.

I want to set the bullet speed based on the click distance like in my previous file. How to add that with the bullet behavior.

That would be the Impulse value. Move the distance calculation there, and adjust as needed.

blackhornet Yes I did. It was very fast but then I divided the whole calculation by 2(***/2). Now it works all fine.

Thanks a lot mate. You saved my day....