snap tool

When using the snap to pixel tool, the values need to be re-typed every time it is turned on(not just checked on and off, but when a different layout is opened). The will display whatever value you used last, but will always be 32x32(the default) until you re-type both of them. A user preference for this would be nice(just a thought).

This is actually by design - the snap setting is remembered per-layout and defaults to 32x32. If you save, close and reopen the project it will remember all the snap settings you've set, but only for the layouts you've changed them on. So you only need to do it once for each layout in your project then it will always remember it from then on.

It remembers the settings but doesn't display it again.

Meaning if I open a capx in which the snap for a layout is 16X16 for example and goes to the ribbon, the value displayed there will be 32X32 (for the modified layout) which is sometime confusing if it is an old capx.

It's minor, but still can be anoying.

Ashley (I forgot)

Oops, you're right, it's a bug. Fixed for next build.

What I've been talking about is different. It saves my settings, lets say 125x125 and that is what it shows, but unless you re-type 125x125 it still snaps at a value of 32x32.