bug in the debugger?

Link to .capx file (required! If link is blocked remove the http and www parts):

dropbox.com/s/h3eku40e03wtill/debugProblem.capx

Steps to reproduce:

1. create a physics object

2. store a velocity from the physics object in a variable

3. compare that variable to the listed result in the debugger for velocity

Observed result:

There is a difference between the stored variable and the velocity of the object as read by the debugger

Expected result:

The variable storing velocity and the debugger reading of velocity should be the same. (are they the same? - is it just a wrong interpretation)

Browsers affected:

Chrome: yes

Firefox: yes

Operating system & service pack:

windows 7 64 bit, service pack 1

Construct 2 version:

Release 158.2 64 bit

* You must run the file in debug mode. and inspect sprite.physics.velocity and compare it to the variable stored velocity.

Thanks, they didn't report the same value and now the debugger shows the same values as the expression. Note that your .capx multiplies the Y velocity by dt though so will still show a different value.

I had it multiplying by dt because that was a lot closer to correct than the not, but still a little off (I originally thought it was a dt issue).

Thanks, will the fix be in the next release?