Thank you for your reply. As far as I know, the drag and drop feature moves the whole sprite across the layout.
Is there a way I could make it fixate it at one end and just increase the width between the two points?
Yeah well you're not really going to drag the whole multimeter sprite across but just the jack sprite.
This is what your multimeter looks like:
So it's going to consist of several parts and not a single sprite.
2 jacks, 1 Knob, 1 body, 1 number display
By the way, I've just seen your capx and it's more complicated than I expected since you're involving a Bread Board.
Plenty of points for each end of your components to snap on. But that makes drawing wires easier now since can use a single 'wire' sprite from one point to the next.